Locomotive Transport Boxes

_MG_0523

When I got my second steam engine and needed a way to transport it to meets safely, I designed a box. I already had boxes for my electric locos. Those boxes required the the locos to be placed in the box and then foam placed on both sides.

Given the box was for a live steam engine, I was concerned about the oil residue and placing a warm loco in a box with foam; that lead me to design a box that held the loco in place with small bungee cords. Eyelets are attached to the bottom for the bungees. The loco is placed on the bottom which has two groove cut at 45mm or track gauge.  The rest of the box is the “top” that attaches to the bottom using a tight seal sash lock. A one inch wide safety strap around the box serves as a backup.

8657934
The strap is made of 1″ nylon strapping and a parachute buckle. I purchased both at Joann Fabrics. The strapping is sold by the yard.

20150212_211232
Bungee cords, handle, tight seal sash lock

The bottom of the box is constructed of a 1X8 cut to whatever length required for the locomotive. The rest of the box is constructed of 15/32″ plywood, glued and screwed together. The screw were countersunk and filled. The entire box was sanded and then painted with satin latex paint. The bottom was stained with maple stain/polyurethane. A border was painted with the latex paint.

The latches were attached to the ends and the handle to the top.

sta-80-1700
On the original box I used this draw style latch.

Loco BoxA crude SketchUp drawing.

Dimensions-
Sides 8.46875″H – Length determined by loco.
Top 6.5″W –  Length determined by loco.
Ends 6.5″W 8″H
Bottom – 7.5″W – Length determined by loco.

_MG_0522
My live steam mogul bungeed down to the bottom of the original box. The handle is offset to compensate for the heavier end where the loco is.

 

Leave a Reply

Your email address will not be published. Required fields are marked *